This will layout the order you should take when working with your 3d Printer board.
First Step install VScode IDE (Integrated developer environment)
This is a basic video on how to install software on board.
This is a basic video on how to configure an endstop switch in Marlin firmware.
This explains a Optical endstop
explains how to setup a basic servo.
This explains basic configuration of BLTouch
This explains how to work with STEP/DIR steppers such as A4988 and DRV8825.
This explains how to install TMC2130 SPI stepper without sensorless homing.
This explains how to install TMC2208 UART stepper.
This explains how to uses Dual steppers .
This explains the concept of a fan extender.
This explains setup of parallel Dual steppers.
This explains the Endstop Switch.
This explains how to add an addition stepper.
This explains how to setup a dual extruder.
This explains how to setup 12864 LCD in marlin firmware.
This explains how to setup a TFT display in marlin.
This explains how to setup TFT mode in Marlin Firmware.
This explains how to upgrade TFT display firmware.